Rear fork without screws, pins or bolts for operators 400-402-413-415-S418 from FAAC
Need Assistance? Click here
If you need assistance read how to do it
Need Assistance? Click here
If you need assistance read how to do it
Availability Information
Click here for more information on product availability.
Availability information
Click here for more information on product availability.
Where can I find the engine model?
To find out where the identification plates on the engines are located click here.
Where can I find the model of the engine?
To find out where the engine identification plates are located click here.
Replacement rear fork for operators models 400-402-413-415-S418. This replacement is supplied without bolts, screws or washers
Specific References
No customer reviews for the moment.
Rear flange of the bottom for hydraulic operator 400, 402, 422 of the FAAC.
Power cable for hydraulic operators old FAAC models (400, 402, 422)
Complete gasket kit that can be used on the 402 operators of the FAAC produced since 2004.
Front fork complete with pin and seeger for 402 hydraulic operator of the FAAC.
Long pin for mounting the rear fork on the operator's end cap 400, 402, 422, S450H of the FAAC.
Short fork/rear bracket mount pin in operators FAAC models: 400, 402, 422, 413, 415, S418
Male connector for motor power cable 400 - 402 - 422 of the FAAC.
Cardboard gasket for hydraulic operators tank of the FAAC models 400, 402, 422
