Sealing ring used in the reduction shaft and crankshaft of the PASS 1200/1800/2500 of the GIBIDI
Availability Information
Click here for more information on product availability.
Availability information
Click here for more information on product availability.
Where can I find the engine model?
To find out where the identification plates on the engines are located click here.
Where can I find the model of the engine?
To find out where the engine identification plates are located click here.
Are you a European company?
To buy with a VAT-free European invoice click here.
Are you a European company?
To purchase with a VAT-free European invoice click here.
Replacement oil seal ring for the PASS operator of the GIBIDI only in the versions:
There are 2 of these rings in each PASS, mentioned above. One is present in the reduction shaft on the release side, while the other is present on the motor shaft on the end flange side.
If you wish to replace both, you will need to purchase twice the quantity of this product.
Specific References
No customer reviews for the moment.
Complete output shaft kit for PASS 600 and PASS 800 operators
Gasket present in the release unit of the GIBIDI PASS.
Magnet retaining screw washer on the inner crown of the PASS GIBIDI
Release slider with spring for PASS sliding operator of the GIBIDI
Replacement cover GIBIDI for operator PASS 4-6-600-800
Replacement handle for unlocking in the PASS operators of the GIBIDI.
Front flange screw for PASS 1200/1800/2500 of the GIBIDI.
Complete motor for sliding gate operator model PASS 820-830-840
Sealing ring for PASS 1200/1800/2500 output shaft of the GIBIDI.
1 liter oil pack for sliding operators model PASS with gears and motor in oil bath
Original GIBIDI replacement cover for PASS 12-25-1200-1800
