Release pin for all PROTON and PHOBOS versions except for the latest PHOBOS AC and BT A.
Availability Information
Click here for more information on product availability.
Availability information
Click here for more information on product availability.
Where can I find the engine model?
To find out where the identification plates on the engines are located click here.
Where can I find the model of the engine?
To find out where the engine identification plates are located click here.
Are you a European company?
To buy with a VAT-free European invoice click here.
Are you a European company?
To purchase with a VAT-free European invoice click here.
This release pin is located in the bottoms of the PROTON and PHOBOS and can be used in all the following versions:
ATTENTION. As you can read above, the new PHOBOS AC and BT A are not mentioned in the list, this is because the release pin is not compatible with these new versions.
Specific References
No customer reviews for the moment.
Additional electronic board for installation and control of electric locks on the low voltage control units of the BFT.
Kit consisting of a pair of electromechanical operators with 220V motor for maximum leaves of 2.00 m.
THALIA control unit of the BFT, which can be used with PHOBOS and ELI 250 BT.
Pair of shells for BFT PHOBOS A and PHOBSO AC joint
Cap kit with Teflon nut for PHOBOS N of the BFT, both in the 24V and 220V versions.
Reduction gear for PHOBOS BT A25 and PHOBOS BT A40 from the BFT.
Complete stem for PROTON and PHOBOS (old series) complete to be replaced
Swivel plug kit with Teflon nut to be used only on the old PHOBOS L of the BFT.
