Bevel gear for PROTON or PHOBOS placed inside the reduction
Availability Information
Click here for more information on product availability.
Availability information
Click here for more information on product availability.
Where can I find the engine model?
To find out where the identification plates on the engines are located click here.
Where can I find the model of the engine?
To find out where the engine identification plates are located click here.
Are you a European company?
To buy with a VAT-free European invoice click here.
Are you a European company?
To purchase with a VAT-free European invoice click here.
Spare bevel gear for BFT for electromechanical operators of the following series: PROTON all versions, PHOBOS all versions.
ATTENTION. This is not the gear placed under the winding but the one that is also found in the primary reduction kit.
Specific References
No customer reviews for the moment.
Complete secondary reduction kit for PHOBOS, PHOBOS N, PHOBOS AC A25, PHOBOS AC A40, PHOBOS AC A50
Cap kit with Teflon nut for PHOBOS N of the BFT, both in the 24V and 220V versions.
Specific grease for repairing automatisms. Used when internal gears of electromechanical operators need to be replaced. 125g tube.
New case back for PHOBOS AC, PHOBOS BT A, KUSTOS, KUSTOS ULTRA
Replacement winding complete with flanges and 220Volt bevel gear for PROTON - PHOBOS - PHOBOS AC
Release pin for all PROTON and PHOBOS versions except for the latest PHOBOS AC and BT A.
Front and rear anchor brackets only for old version PHOBOS (the one with the telescopic stem).
Additional electronic board for installation and control of electric locks on the low voltage control units of the BFT.
