Low-profile rubber edge (just over 2 centimetres) to be applied as a passive component on sliding, hinged, up-and-over or sectional doors. This profile cushions the impact in the presence of the electronic anti-crush.
THE PRICE OF THIS PRODUCT IS FOR 1 METER, AND YOU CAN BUY A MINIMUM OF 2 METERS.
Availability Information
Click here for more information on product availability.
Availability information
Click here for more information on product availability.
Where can I find the engine model?
To find out where the identification plates on the engines are located click here.
Where can I find the model of the engine?
To find out where the engine identification plates are located click here.
Are you a European company?
To buy with a VAT-free European invoice click here.
Are you a European company?
To purchase with a VAT-free European invoice click here.
Passive protection rubber profile. This means that this tire does not have any electronic board or device that can be connected to the control unit of the automation system. The BIR C of the BFT is a simple rubber safety edge that cushions the blows, generated by possible collisions between the moving leaf of a sliding gate (for example) and an obstacle.
This type of protection is particularly suitable in cases where there is already an electronic anti-crushing device and you want to further cushion any impacts. The low profile is very important on the overhead doors.
THE PRICE OF THIS PRODUCT IS FOR 1 METER, AND YOU CAN BUY A MINIMUM OF 2 METERS.
The product comes with its aluminum rear rail (as pictured). The guide allows installation on any type of surface. The guide will be installed first and then the rubber will be inserted into the profile.
To complete the product, 2 rubber plugs are also supplied, one upper and one lower, since the rib is hollow inside.
Sheet
Specific References
No customer reviews for the moment.
Transmitter for sensitive edges in IP67 watertight enclosure with 868MHz operating frequency, certified.
12/24Vac/dc powered detector for magnetic loops, single-channel input, 2 relay output
Reflectors of different shapes depending on the flow rate you want to achieve with the REFLEX photocell
Transmitter with 8K or NC input for connection to ribs via radio or magnetic contacts.
Pair of small photocells for special applications with little space available.
Retroreflective photocell kit with anti-condensation accessory, up to 12 m.
Anti-reflective cover for rectangular retroreflector of the REFLEX retroreflective photocell.
Full-length active safety edge, flush connection, length 2.0 m.
Aluminium column with ABS base and cap height 50 cm.
Magnets with reader for definition of NO-TOUCH edge inhibition zone
Anti-reflective cover for round reflector of the REFLEX retro-reflective photocell.
Radio receiver can only be used with radio ribs model PS-105-008 or as a replacement for the receiver of the KS-105-008 kit.
Receiver for 868MHz sensitive edge contact transmitters with the possibility of storing up to 6 transmitters.
