Ready-to-use wired coil for metal mass detector.
Availability Information
Click here for more information on product availability.
Availability information
Click here for more information on product availability.
Where can I find the engine model?
To find out where the identification plates on the engines are located click here.
Where can I find the model of the engine?
To find out where the engine identification plates are located click here.
Are you a European company?
To buy with a VAT-free European invoice click here.
Are you a European company?
To purchase with a VAT-free European invoice click here.
Wired and ready coil with a long side length of 3 meters and a short side of 2 m.
Connection cable length 10 m.
Can be used with any metal mass detection device.
Sheet
Specific References
No customer reviews for the moment.
Transmitter with 8K or NC input for connection to ribs via radio or magnetic contacts.
Pair of complete photocells compatible with both FAAC and BFT.
Aluminium column with ABS base and cap height 50 cm.
Pair of small photocells for special applications with little space available.
Transmitter for sensitive edges in IP67 watertight enclosure with 868MHz operating frequency, certified.
Sensitive security edge for sliding gates with NO-TOUCH technology and wireless height costs 2.00 meters.
Receiver for 868MHz sensitive edge contact transmitters with the possibility of storing up to 6 transmitters.
Additional radio cost for use with PS-105-009 receiver or in addition to the KS-105-008 kit. Batteries included.
Magnets with reader for definition of NO-TOUCH edge inhibition zone
Full-length active safety edge, flush connection, length 2.0 m.
Radio receiver can only be used with radio ribs model PS-105-008 or as a replacement for the receiver of the KS-105-008 kit.
12/24Vac/dc powered detector for magnetic loops, single-channel input, 2 relay output
